U2366 Pininfarina Corvette Engine Fault Code

Check Solution For U2366 Pininfarina Corvette OBD Code :

U2366 Pininfarina Corvette engine code seems a kind of network problem, we try to show one by one the meaning and the solution.
Brief explanation of the U2366 Pininfarina Corvette code and definition of U2366 Pininfarina Corvette is the bottom side.

U2366 Pininfarina Corvette Meaning :

u Network Code
Problem is climate control system, lighting, airbags, etc.
2 MFG - Manufacturer Specific
3 IC Module 4X Ref Circuit Intermittent, No Pulses
6 Control Module Throttle Actuator Position Performance
6 Cruise Control System - Vehicle Accel Too High

MFG - Manufacturer Specific codes, which have a '1' as their second digit to indicate they are unique to a particular vehicle make or model. These special codes were deemed necessary by the vehicle manufacturers so they could provide additional diagnostic information beyond the basic list of generic OBD II codes for all kinds of faults, not just emissions-related faults.

How To Fix U2366 Pininfarina Corvette ?

Is the fuel pump sometimes not priming when you turn the key to ON(II)? Start by measuring the fuel pressure and checking whether you have bright white-bluish spark at all four plugs. The mechanical timing is also something that you should check, as we mentioned above.

U2366 Pininfarina Corvette Code Description:

The engine system, in conjuction with the engine control module (ECM)/powertrain control module (PCM), activates the U2366 code solenoid valve to control oil pressure to the engine mechanism that is installed in the valve system to switch valve timing between Low and High.If the engine solenoid valve has an open or short circuit, a DTC is stored. When you see U2366 Pininfarina Corvette engine fault code on your engine code reader this description will help you.

U Codes List of all Network codes.

Final Step: In the definitions listed below, there is a test drive recommended after you've completed any repairs to see if the condition is fixed. Before you take a test drive after a repair, always erase the U Code(s) first. This will turn the check engine light off and then you will know if the check engine light returns, you've got further diagnostics to complete.

BE CAREFUL !
This engine code information is presented for information purposes only. This is not intended as repair advice and we are not responsible for any actions you take on any vehicle.

About Us | Contact | Privacy

Copyright © 2016 - EngineFaultCode.com
All rights reserved.
Sitemap

Valid CSS!